水泥砖机器生产
Cement brick machine production
将制砖底模具放入模具钢套内。均匀撒上一层面料大概0.5-1厘米厚度就行。然后放入底料加满模具钢套。让后将模具推入机器压顶下<注意一定要推到底。不能推了为止，因为有定位，如果推拉不到位会压偏了损伤模具》。然后推下大个操纵杆压制。压实机器声音一变。在回拉操纵杆，将压头抬起，将模具拉出。拉到底不能动了位置，也是定位。这点要非常注意。推动小的操纵杆将模具底板和水泥砖一起顶出。将砖直接拿走码垛。在将模具底板放入模具框内继续压制就行了，
Put the brick bottom mold into the mold steel sleeve. Spread a layer of fabric evenly, about 0.5-1cm thick. Then put in the bottom material and fill the die steel sleeve. Make sure to push the machine to the bottom. Can not push until, because there is positioning, if the push-pull is not in place, it will bias the damage to the mold. Then push down the large lever to press. The sound of the compaction machine changed. Pull back the lever, lift the ram and pull out the mold. Pull to the end can not move the position, but also positioning. We should pay great attention to this point. Push the small control lever to push out the mold bottom plate and the cement brick together. Stack the bricks and take them away. After putting the mold bottom plate into the mold frame, continue to press,
要非常注意的是推拉模具都要到位，防止压制和顶出的时候偏离，会损伤模具，不明之处资讯方圆建筑材料。
It should be noted that the push-pull molds should be in place to prevent the deviation during pressing and ejection, which will damage the mold and the unknown information, square and round building materials.